AR-15 (and other variants) questions, answers, bullshit

Itaro

Seriously, FJB
Joined
Oct 5, 2018
Messages
13,115
Mine is a 10.5” barrel. With a kak slim flash can.
Had a good time with the wife. She got acclimated with her sig. the ruger ar is ok. The one I built is a blast to shoot.
AR pistols are fun. Been thinking of getting that brace but it’ll rarely get used since I focus more on distance
 

Itaro

Seriously, FJB
Joined
Oct 5, 2018
Messages
13,115
Man, larue raised the prices on triggers (flat face 2 stage) and brownells is running a sale on geissele.

geissele would still be $70 more hmmmmm
 

4runner DOA

Hold my beer
Staff member
Joined
Oct 2, 2018
Messages
15,882
Location
OC
Good man, learn how to remove the juggernaut pin enough to separate the upper from the lower without it popping out. Mine would and then I’d have to disassemble it more. Was annoying

I've had to pop that fucking pin back in with my knife so many times but I've got it down now.
 

Itaro

Seriously, FJB
Joined
Oct 5, 2018
Messages
13,115
I've had to pop that fucking pin back in with my knife so many times but I've got it down now.
That’s mainly the reason I went featureless. Also you’re not supposed to use standard capacity magazines with a break open AR. It’s fucking ridiculous
 

Dezert4Runner

Pineapples belong on pizza
Joined
Oct 23, 2018
Messages
1,172
Good man, learn how to remove the juggernaut pin enough to separate the upper from the lower without it popping out. Mine would and then I’d have to disassemble it more. Was annoying
The real adjustment is on the mag release in their modified catch latch, so the rear pin shouldn’t need adjusting, correct? I belive that’s where their instructions say the adjustment needs to be made before the set screw loc-tite sets.

For the rear pin, I could see the thumb screw with the spring in the left side backing off enough to cause trouble with the separating action.
 

Itaro

Seriously, FJB
Joined
Oct 5, 2018
Messages
13,115
The real adjustment is on the mag release in their modified catch latch, so the rear pin shouldn’t need adjusting, correct? I belive that’s where their instructions say the adjustment needs to be made before the set screw loc-tite sets.

For the rear pin, I could see the thumb screw with the spring in the left side backing off enough to cause trouble with the separating action.
try opening it to remove the BCG/CH to clean it and if the rear pin gets pushed too far it could completely put out
 

Dezert4Runner

Pineapples belong on pizza
Joined
Oct 23, 2018
Messages
1,172
try opening it to remove the BCG/CH to clean it and if the rear pin gets pushed too far it could completely put out
Gotcha. I struggled big time trying to line up the pin and the upper for some reason. If that detent pin lets it pull all the way out, I’d be less than thrilled
 

Itaro

Seriously, FJB
Joined
Oct 5, 2018
Messages
13,115
Gotcha. I struggled big time trying to line up the pin and the upper for some reason. If that detent pin lets it pull all the way out, I’d be less than thrilled
There’s a version of the pin out there with a long detent and a shorter spring that has less issues. I used to know which one but I’m more of a fan of featureless than the break opens right now

Are you going to put optics on it?
 
Top Bottom