IDJITFor the time being, me
IDJITFor the time being, me
What idiot would keep the stock diff.
Weren’t you all stoked about 1 ton ifs? Or were you full of shitI'll probably build a full up tube buggy before I change that diff. At the point I'm replacing the front diff, there are so many other limitations of the taco chassis that it's not worth it.
Weren’t you all stoked about 1 ton ifs? Or were you full of shit
I ask the fucking questions, you give the fucking answers.I'm all about a 1 ton IFS, I just wouldn't put it on a Taco chassis. Even if I put a taco body on the resulting rig.
At the point I'm rebuilding the front frame for the IFS and motor why not do the whole thing and fix the weak ass C channel in the back?
I ask the fucking questions, you give the fucking answers.
Thought I was still talking to assburns too lol.
I stopped caring. No way I’m chopping the entire frame without replacing the axle and a LS motor. Eventually I’d love to do that, but that’s not happening anytime soon. Need more time and much more money for that.I ask the fucking questions, you give the fucking answers.
Thought I was still talking to assburns too lol.
Man that would be so rad, but damn that shit is not cheap. Spydertrax makes an even narrower one that lets you get closer to a true center mount, but that’s even more expensive.
Mmm something worth as much as my whole truck.
I stopped caring. No way I’m chopping the entire frame without replacing the axle and a LS motor. Eventually I’d love to do that, but that’s not happening anytime soon. Need more time and much more money for that.
.
Hey @theesotericone can you measure your RCV outer CV cup diameter for me?@theesotericone can you measure your RCV axles for me. I need the measurement of the outside diameter of the outer CV cup. These Napa’s are almost 92mm.
View attachment 8773
Hey @theesotericone can you measure your RCV outer CV cup diameter for me?
Thanks! I'll go with 100mm to leave a little room for any error. I guess I could call RCV and ask too.About 97mm. My calipers might be to small to get an accurate number. It looked like they where close to center but they might have been a bit short. I'm not planning on pulling the CV anytime soon but if I do at some point I'll get you a more accurate number.
Thanks! I'll go with 100mm to leave a little room for any error. I guess I could call RCV and ask too.
@Tetten has measurements on his long travel RCV's in the CV Axle thread. Those might be a better number to use.
Different CV’s most likely.@Tetten has measurements on his long travel RCV's in the CV Axle thread. Those might be a better number to use.