We will have my brothers GX up there when his rack is ready. Should be about fully built by then. We'll have to get some photos with you photographers/metal fabricators up there.
Did you clock the black cover when you put it back on? If we are talking about the same cover on TC actuator motor. When I put mine back together I stuck it straight back on which put it out of timing with the front actuator or something like that. Also be careful with that O-ring cause it's...
Hell yeah. That'll be a nice setup for sure. Nothing really out there custom for the third gen except for the jl stealth box. Which still takes up too much room in my opinion and are hard to come across. Not to mention insanely expensive. Built my whole set up for about $80 in material and a few...
Been in any water lately? My 02 did the exact same thing after I dropped through the ice on the South Platte. The breather tube had come off the transfer case actuator motor and filled it with water. Made the electronics in there unhappy. Pulled it off, drained it and reattached the breather...
So this happened recently. Now have a locked '02 after months of forum inactivity. Heading out for further testing this weekend. Got a good deal on a complete rear axle, front diff, locker ecu, full harness and factory switch. All out of a lower mile, dealer maintained 2000. (Thanks Trevor)...
Learned the hard way recently. Fender liners were trashed post tub job and fender clearancing for the 35's. All good until driving home from AZ in a rain storm. Air filter was taking on water and cutting air to the engine. Pulled the filter and it was completely water logged. Could barely...
Expo West 2019 in Flagstaff AZ was a blast. Met a bunch of cool people and scored on a couple great deals. Hit the Grand Canyon on the way home. Cloudy and raining though.
Drawer system complete and fridge installed. Ready to test it out on the few trips already planned for this month and next. Rocked the drawers down to Expo West and it beats the hell out of digging though plastic tubs all day long.
Phase one of the drawer system build is complete. hoping to get the slides installed and drawers built over the weekend. Can't wait to get a little more organized.
Had an amazing weekend camping and wheeling with old friends and new. Camp site was legit right off the river. Left my truck at base camp to ride with my brother whose truck we are in the process of building. This was his first trip out with it. Still need to install the bumpers and skids...
Some poser driveway shots with the fenders trimmed, rolled, and painted post tub job. Everything ready to go. Next shots should be on a trail somewhere finally.