Search results

  1. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    Ratchet. Not too keen on adding the hammering effect of an impact due to possible slippage and death. It did take some effort but wasn't hard to do.
  2. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    I have that one. Handles 700# coils with ease
  3. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    The PUC would disagree. And fuck all you electricians.
  4. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    I would buy if closer. Need another one to run more sump pumps. Ice/water was within half inch of the top of the footings this morning. Of course temp power is still months away...
  5. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    Loud generators work fine on jobsites
  6. Stairgod

    Uniball LBJ from Anonymous Fabrication

    Pretty slick. Not being intimately familiar with the 1st/3rd gen LBJ's this seems like a damn good thing
  7. Stairgod

    Ultra4 4628 Race Car - Sherpa Motorsports

    Nate from Dirt Lifestyle mentioned you guys in his last video. Can't wait to see the race
  8. Stairgod

    Wheel well liner

    Stay on road then
  9. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    I am at the point where I may need to go with a ceiling mount
  10. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    I don't but now I may need to make one
  11. Stairgod

    Heim Steering

    Mine from JD are not tapered
  12. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    Same thing I asked myself. I have emptied the chip tray at least three times and my blade is still good.
  13. Stairgod

    LED Offroad Lighting Recommendations?

    I have spots and floods from him. Still work and still look good. Lenses are as durable as my Rigids
  14. Stairgod

    Welders, welding, and stuff

    My truck is heavy and apparently I am stupid. Crossmember is already bent. Luckily the main part of the front skid is supported by the JDFab LCA tab tubes, and I made a mid support that sits right next to the diff. All the ribs are for the part that ties the front bumper into the main skid. Put...
  15. Stairgod

    Welders, welding, and stuff

    Yep Went with 1/4" flat bar this time. 1/8" didnt work out so well last time.
  16. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    @Arcticelf I believe Nate from Dirt Lifestyle has the same saw and I know for a fact he cut his links for his Land Rover project on it.
  17. Stairgod

    Tools and Shop Talk - Opinions, Thoughts, Reviews, B.S., etc.

    No sir. Deck plate is flat as I am capable of measuring. Very minimal slop in the pin for the 45 and 90° stop. Both are accurate enough for the medium, but I wouldn't try cutting prefinished crown molding on it!
Top Bottom