Making a set of arms for stock mounts on 4runner (w Keith’s reinforcement brackets).
Lower rears using 2.63 Ballistic joints, cups on both ends; non-adjustable lowers. 1.75 DOM.
Q: does the tube need to be offset low on the front cup for clearance? Just noticed these by Resz have offset. Is this for arm clearance or zerk access or? Can 1.75 tube be centered on 2.63 diameter cup?
Lower rears using 2.63 Ballistic joints, cups on both ends; non-adjustable lowers. 1.75 DOM.
Q: does the tube need to be offset low on the front cup for clearance? Just noticed these by Resz have offset. Is this for arm clearance or zerk access or? Can 1.75 tube be centered on 2.63 diameter cup?
Last edited: