Dezert4Runner
Pineapples belong on pizza
- Joined
- Oct 23, 2018
- Messages
- 1,176
That’s a great idea since they can easily hang from the pin neck and take some damage before needing replacement.You can make a gallows and hang a few. Make them dance
That’s a great idea since they can easily hang from the pin neck and take some damage before needing replacement.You can make a gallows and hang a few. Make them dance
Mine is a 10.5” barrel. With a kak slim flash can.Is it just me or is putting a pistol brace on something rifle length a thing?
AR pistols are fun. Been thinking of getting that brace but it’ll rarely get used since I focus more on distanceMine is a 10.5” barrel. With a kak slim flash can.
Had a good time with the wife. She got acclimated with her sig. the ruger ar is ok. The one I built is a blast to shoot.
I can’t afford to be a basic idiotapparently I’m a basic idiot on youtube/gram
Turns out I'm a boss thenapparently I’m a basic idiot on youtube/gram
Where’s the “I’m a potato” one? Cause potato is me
Good man, learn how to remove the juggernaut pin enough to separate the upper from the lower without it popping out. Mine would and then I’d have to disassemble it more. Was annoying
Good man, learn how to remove the juggernaut pin enough to separate the upper from the lower without it popping out. Mine would and then I’d have to disassemble it more. Was annoying
That’s mainly the reason I went featureless. Also you’re not supposed to use standard capacity magazines with a break open AR. It’s fucking ridiculousI've had to pop that fucking pin back in with my knife so many times but I've got it down now.
The real adjustment is on the mag release in their modified catch latch, so the rear pin shouldn’t need adjusting, correct? I belive that’s where their instructions say the adjustment needs to be made before the set screw loc-tite sets.Good man, learn how to remove the juggernaut pin enough to separate the upper from the lower without it popping out. Mine would and then I’d have to disassemble it more. Was annoying
try opening it to remove the BCG/CH to clean it and if the rear pin gets pushed too far it could completely put outThe real adjustment is on the mag release in their modified catch latch, so the rear pin shouldn’t need adjusting, correct? I belive that’s where their instructions say the adjustment needs to be made before the set screw loc-tite sets.
For the rear pin, I could see the thumb screw with the spring in the left side backing off enough to cause trouble with the separating action.
Gotcha. I struggled big time trying to line up the pin and the upper for some reason. If that detent pin lets it pull all the way out, I’d be less than thrilledtry opening it to remove the BCG/CH to clean it and if the rear pin gets pushed too far it could completely put out
There’s a version of the pin out there with a long detent and a shorter spring that has less issues. I used to know which one but I’m more of a fan of featureless than the break opens right nowGotcha. I struggled big time trying to line up the pin and the upper for some reason. If that detent pin lets it pull all the way out, I’d be less than thrilled