@AssBurns @Epsilon @Blender
Do you guys have suggestions on preventing "lifting"?
I've done some reading already, but would like your guys input/advice if you have the spare time to comment.
My research has stated to:
1) Slow down the print speed
2) Use a Glue Stick (Note: I do use one)
3) Heated Bed (Note: mine is not capable)
4) Slicer Settings (i.e. brim, wall, etc)
5) ... the list kind of goes on a bit more
Anyways, I haven't "experimented" with any slicer settings yet.
This box/chassis is my first "large print" (L=3.5in x W=2.85in x H=1.65in)
Still totally usable for what I need it for, but for future projects I would like to take care of the "lifting".
View attachment 35652
View attachment 35653
In the picture below, you can clearly see the "lifted corners". I have Blue Painters Tape and I was wondering if that will possibly help? I do know and understand though that it is heat/cooling is the main issue that causes lifting. But anyways, thoughts anyone?
View attachment 35654
I needed a box/chassis for my circuit project I'm doing for my RC car motors... Anyways...
View attachment 35655
View attachment 35656