lowellwatt
What if diabetes has a knife?
I'm going to be doing a lot of dumb shit this year preparing for Moab in the fall, so I figured I'd start a build thread to keep track. Pic below is pretty much how it sits right now, here's the current list of stuff on the '02:
King 2.5 extended travel w/ 650lb springs in front
SPC UCA's
Toytec Superflex w/ 4th gen/FJC 5100's in back
SS rear sway bar brackets
1" Toytec body lift
Energy body mount and rack bushings
Durobumps front and rear
eimkeith PCK
Tom Wood's rear shaft
4.88s from Low Range
elocker swap
1" diff drop from wherever
B&M trans cooler in series with radiator
4xInnovations front armor and sliders
Smittybilt 9.5K XRC w/ synth line
Coastal Offroad rear armor
RCI front skid
Homemade 7 gauge steel drivetrain skid
Tundra brakes w/ DBA rotors
KO2's in 285/75r16
Pro Comp 7069's
Uniden 505XL CB
???
PROFIT
I have a pile of stuff waiting to get done but it's been too cold here to spend any time in the garage. Still have to build the rear swingout and all that. I debated wether or not to even do a thread, only because I'm much of a consumer than a contributor when it comes to 4Runner stuff; I pretty much learn everything from you guys and hack it onto my rig. Hopefully somebody will get something of value out of this, possibly what not to do, or revel in my agony. This is my DD until I buy a shitbox to ferry parts around with. Enjoi!
King 2.5 extended travel w/ 650lb springs in front
SPC UCA's
Toytec Superflex w/ 4th gen/FJC 5100's in back
SS rear sway bar brackets
1" Toytec body lift
Energy body mount and rack bushings
Durobumps front and rear
eimkeith PCK
Tom Wood's rear shaft
4.88s from Low Range
elocker swap
1" diff drop from wherever
B&M trans cooler in series with radiator
4xInnovations front armor and sliders
Smittybilt 9.5K XRC w/ synth line
Coastal Offroad rear armor
RCI front skid
Homemade 7 gauge steel drivetrain skid
Tundra brakes w/ DBA rotors
KO2's in 285/75r16
Pro Comp 7069's
Uniden 505XL CB
???
PROFIT
I have a pile of stuff waiting to get done but it's been too cold here to spend any time in the garage. Still have to build the rear swingout and all that. I debated wether or not to even do a thread, only because I'm much of a consumer than a contributor when it comes to 4Runner stuff; I pretty much learn everything from you guys and hack it onto my rig. Hopefully somebody will get something of value out of this, possibly what not to do, or revel in my agony. This is my DD until I buy a shitbox to ferry parts around with. Enjoi!