Canadian pussy thread

[Blender]

Might be

[user was banned for this post]

no messing around that's for sure

 

[Hank]

I’ve also got it held up on top by the body. Still sketchy haha.

Should have let us all believe that it was just a little stick holding it up.

 

[theesotericone]

I did a nice weld!!

Even a blind squirrel finds a nut every once and a while. lol

Did you mention what front axle your using? Are you adding dual cases while it's all apart and easy to get to?

 

[eimkeith]

Even a blind squirrel finds a nut every once and a while. lol

Did you mention what front axle your using? Are you adding dual cases while it's all apart and easy to get to?

He’s already dual cases

 

[theesotericone]

He’s already dual cases

For a driver side drop. That's why I asked about the front axle.

 

[eimkeith]

Ah so!

 

[theesotericone]

Axle is driver drop too. 2012 superduty axle

Dana 60. That should hold up just fine.

 

[AssBurns]

Dana 60. That should hold up just fine.

The 04+ Super Duty 60's are fucking monsters. They will handle 42's all day long with no problems.

@Rapier46 doing a Sterling 10.5 in the rear?

 

[AssBurns]

14 bolt rear

Can't go wrong with that. Have you shaved it yet?
A shaved sterling would be rad too.

 

[AssBurns]

As much as this disappoints me, I am still getting boners over these posts.


Also those tires...

 

[Duckbutter6]

Here’s where I got to tonight. Both side frame rails welded on, plates on the outside of each.

Next is to plate the inside of the joint between old and new, then I would like to get a bumper set back onto the front or at least join the two front tube with a strong tube at the front so I can let the engine weight down on it again and not worry about it flexing.

Got my gears, and tires obviously. Still waiting on a bunch of goodies. But I can keep fabricating for now. Lots to do up front still to prepare for the axle.

I knew this was going to be expensive, but holy shit.


Also these tires are absolutely ducking uuuge

Question.
Will you clear the garage door when it’s ready to roll out?

 

[TCMach]

Also these tires are absolutely ducking uuuge

Interested to hear what you think of those tires. I ran Mickeys for a long time and loved them. Would've gotten the MTZ P3s when I went to 37s but my Falkens showed up on CL for 600 bucks.

 

[weekendclimber]

You should just chop this all up and weld it back in

 

[weekendclimber]

Damn! My sense of humor doesn't work on this forum either

 

[eimkeith]

Damn! My sense of humor doesn't work on this forum either

I thought it was funny; reference to his bed work.

 

[Duckbutter6]

got the frame plated inside and out at the joint.


Now what??? Not even sure what to do now

Lol these tires are ridiculous

Is this what Legends are made of?

 

[weekendclimber]

I thought it was funny; reference to his bed work.

My wife would tell you to stop encouraging me.

 

[eimkeith]

My wife would tell you to stop encouraging me.

same.

 

[Duckbutter6]

My wife would tell you to stop encouraging me.

same.

You two done touching each other’s dicks?

 

[eimkeith]

You two done touching each other’s dicks?

Just getting started